Problem:
Using Autopropad G2 and Autel KM100 on a F-150 2019 Keyed ignition.
No keypad on door.
Active alarm.
After waiting 10-15 min, alarm beeps twice, then when i add a key the alarm starts beeping again with a note (security authentication failed).
Tried All keys lost.
Tried it under type 10 2017 fusion.
Tried under smart key.
No matter what i do, after the 2 beeps the alarm goes on again.
Any ideas what can be done to program a key?
Solution:
Here is the tip to program Ford F-150 key with active alarm.
Use Autel all keys lost.
Put screw driver on the door latch wait 10 minutes when you hear the twice alarm, hit ok.
It will read security and then the alarm will go off again.
Wait for twice alarm them hit ok. It will program the keys since it reads the security first time.
Keep in mind that you have to connect to a running car.
Door latch has to be closed with screw driver until the programming done.
If you have done the screw driver, when it beeps again let it be and wait for 2 beeps again.
Don’t disconnect anything wait for it and then hit ok it will go programming mode right away.
OBDSTAR, Xhorse and Auto prog pad also have Ford AKL adapter to bypass active alarm. You can also take the Ford FDRS. Even with frds you have to wait the 10 minutes but it goes through from first try.
User feedback:
Solved with KM100. Sit in the car the whole 10 minutes, skip the open door to power up. I used the KM100 and it worked fine when the Ford was in alarm.
Source link
